Commercial | Domestic | Industrial
Commercial
Dental Directory
We carried out a rewire on two factories. We fitted a new 1200 AMPs per phase, main cabinet complete with a stand by 1000 AMP generator - we used galvanised trunking and conduit throughout and all 300 fluorescent lights were mounted to this trunking. We wired 150mm steel wire armoured cable 8 metres high on ladder racking to feed all the automated conveyor systems fitted through the whole warehouse. 6 x 3 phase boards were mounted at intervals to allow for easier wiring and localised isolation.
MTM Plant Hire
We wired upstairs and downstairs offices, sales areas, toilets, workshops and canteen all using galvanised trunking and single cables. All recessed fluorescent light fittings were used for their even distribution of light. The offices and factory were fed by using 2 x 3 separate phase boards. 400 watt metal halide low bay light fittings were used to light the factory unit. The mezzanine floor was lit using 6 foot twin fluorescent fittings activated by a passive infra red detector with a timer. The whole warehouse is protected by CCTV and a 4 zone fire alarm panel.
Dannys Bar
We were asked to come up with something very different in the area and we designed this lighting structure. We used 3 inch galvanised trunking and fitted 120 chrome spot lights as well as all power and fire alarm cables. The trunking is twin compartment to allow for fire alarm, CCTV and speakers to be run separate to all mains voltage wiring. The spot lights were wired with dimmers so that every 8 spot lights could be dimmed separately.
Hartest Barn
We are currently wiring two Barn conversions complete with garages and annex. The 1st barn has been rebuilt and rewired. All bathrooms have had chrome spotlights fitted. The vaulted ceiling in the lounge has been lit by chrome spotlights mounted on the oak cross beams as well as wall up lights.
New build and rewire
This new build house and rewire was going to be used as a bed & breakfast and residential premises. The houses were wired as normal and downlights fitted in the kitchen and bathrooms. the main house and bed & breakfast - both have split load RCD boards.
Industrial
Nottingham Factory
This factory needed a 180mm steel wire armoured cable to be run from the mains to the other side of the factory in order to have shorter cable runs for 12 heavy taking machines, which have large power consumption. The 17000 square foot factory had to be lit by metal halide low bay fittings and all fittings were wired using 4 inch galvanised trunking suspended from the purlins using 10mm galvanised threaded stud.
Churchfields
We wired 12 starter factory units with an office and WC in each unit. A single phase board was fitted supplying sockets, lighting emergency lighting and smoke alarms in both factory and office space. All BT's were wired to main BT point. The outside lights were 70watt metal halide fittings.
